Alarm
AHD Hybrid DVR User Manual
35
Buzzer:
If selected, the local buzzer would be activated on an alarm.
Show Full Screen:
If selected, there will pop up the chosen channel on the monitor on an
alarm trigger.
To Alarm Out:
If selected, this would trigger external relay output on an alarm.
Email:
If selected, the AHD Hybrid DVR will send an email alert to the preconfigured email
address in case of a sensor based alarm from the particular input.
Snap:
If selected, the system will snap images of the checked channels on an alarm and save
them in the HDD automatically.
⑦
Go to “To Record” tab. Select recording channels. It would be recorded in case of an
alarm. Click OK button to save the setting.
⑧
Go to “To PTZ” tab. Set preset, cruise and track options for a PTZ in case of a sensor
based alarm. Single or multiple PTZ units could be programmed to perform this function
on the same alarm.
⑨
Go to “Schedule” tab. The setting steps for schedule for sensor based alarm are similar
to normal schedule setup. You can refer to
Schedule Recording
for details. This step is
very important for sensor alarm. Even if you have enabled the sensor alarm for all
channels and set up the trigger, you will not see the result of sensor alarm if no schedule
is added.
If you have set schedule for sensor based recording in the same timeline, recordings can also
be triggered.
9.2 Motion Alarm
Operate the following steps to configure motion based alarm:
Motion alarm includes two sub menus: motion and schedule. The steps to set motion alarm are
as follows:
①
Go to Main Menu
Setup
Alarm
Motion.
②
Enable motion alarm, set alarm hold time which refers to the time till which the system
will wait for further detection of motion. e.g. If the holding time is set to 10 seconds,
once the system detects a motion, it will go to alarm but would not detect any other
motion alarm (specific to channel) until 10 seconds. If there is other motion detected
