6.6
SELECTING OUTPUT VOLTAGE/CURRENT
The output voltage/current at TB5.1(+) and TB5.2(-) is set by positioning jumpers on JP6 as shown below. JP6
must be set for 0 to 10 vdc when the PA-2 or PA-90 Power Amplifier is used.
The –10 vdc to +10 vdc output is normally used with regenerative drives in torque mode. If the drive is wired so
that +10vdc creates torque in the first quadrant, use SYSTEM TYPE 2 or 4. Otherwise use SYSTEM TYPE
1 or 3. In either case tension can now increase or decrease from T1 to T2. See Figure 1.
If the PA-2 or PA-90 Power Amplifier is used, select current and voltage per Figure 2.
6.7
+5vdc SUPPLY (TB3.5(+) to TB3.6(-))
Total current capacity is 150 madc. Subtract sensor current of:
30 madc per MAGPOWR sensor
45 madc per 120 ohm sensor connected per Section 6.1
6.8
OPERATOR SCREENS
The operator screens are those normally used during machine operation and are accessed using
NEXT ITEM
or
PRIOR ITEM
from the
HOME
screen. These are the only screens affected by the language selected per Section
6.10 and the only screens which are accessible when security is set per Section 6.17. The operator screens are
)
TENSION
(
,
)
DESIRED TENSION
(
,
)
MANUAL LEVEL
(
,
)
OUTPUT LEVEL
(
,
)
TAPER PERCENT
(
(if TAPER
TENSION is selected), and
)
WEB SPOOL WIDTH
(
(if INERTIA COMPENSATION is selected).
6.9
UNITS OF MEASURE
PROGRAM-CONFIGURE can be used to select units of measure from:
ENGLISH (lb, in)
METRIC (kg, mm)
METRIC (n, mm)
6.10
LANGUAGE
PROGRAM-CONFIGURE can be used to select different languages. The selected language is used for the
operator screens which are
)
TENSION
(
,
)
DESIRED TENSION
(
,
)
MANUAL LEVEL
(
,
)
OUTPUT LEVEL
(
,
)
TAPER
PERCENT
(
and
)
WEB SPOOL WIDTH
(
. The available languages are:
ENGLISH (factory default)
FRANCAIS
DEUTSCH
ESPANOL
ITALIANO
8
