Magnusson 3663602850878, Manual, Page: 6 / 60

6
CAUTION!
• ALWAYS turn off the instrument before replacing the batteries.
• ALWAYS remove the batteries if the instrument is not to be used for
extended periods.
• ALWAYS use high quality batteries of the same brand, type and age.
• If the instrument does not work properly, or the low battery icon is displayed,
replace the batteries immediately.
• DO NOT expose the batteries or instrument to extreme temperatures or direct
heat source, as this can cause the batteries to leak.
• If the batteries should leak, remove them using a cloth and dispose of them
according to local regulations. Clean any leaked battery acid avoiding any contact
with skin, eyes & mouth.
• If any contact does occur, rinse affected areas immediately with fresh water and
seek medical advice.
Functions and settings
01 Operation instructions
1. Press to turn ON.
2. Press to switch between “cumulative” and “area” modes, and to select front or rear datum measurement.
3. Press & together to switch between metric and imperial units.
In single measurement mode:
4. Press to turn on the laser. The laser will turn off automatically after 20s if no measurement is taken.
5. Point the laser at the target and press again to record the distance.
6. Repeat steps 4 and 5 to take the next measurement. The screen will display the current, and the 2 previous readings.
7. Press and hold for approximately 2 seconds to enter continuous measurement mode.
In cumulative measurement mode:
8. The screen will display the last
total distance, the last measurement, and the new total distance.
In area measurement mode:
9. Press to turn on the laser.
10. again to record the distance.
11. Point the laser at the second target and press again to record the distance. The screen will display the 2 measurements and
the total area.
12. Press and hold to switch OFF. The device will switch off automatically after 5 minutes if no buttons are pressed.