10
1. LCD DISPLAY
This display shows the controller status in, MANUAL and AUTO (remote start) modes.
Should a shut down fault occur, the LCD display will show the condition causing the fault. At the
same time, the engine will shut down and lock out.
The LCD display will also show any possible Engine Sender Failures and Time To Service
information. These conditions will not shut down the engine; they are used to alert the operator.
2. OPERATION KEYS
MANUAL
Press to switch from AUTO to MANUAL mode.
AUTO
Press to switch from MANUAL to AUTO mode for remote starting of
generator.
ENGINE START
Press to start engine.
ALARM CANCEL
Press to cancel alarms (visual or audio if equipped).
FAULT RESET
Press to clear ALARM LIST fault codes.
ENGINE STOP
Press to stop engine.
3. CONTROL POWER SWITCH
This main power switch turns the controller on and off.
4. VOLTAGE ADJUSTMENT RHEOSTAT
This knob allows the end user to fine adjust the output voltage from the generator.
5. OPERATION STATUS LED’S
ALARM / FAULT
Indicates active or inactive alarms.
READY / MANUAL
Indicates controller is in MANUAL mode, ready to start.
RUNNING
Indicates running engine.
WARNING
Indicates active or inactive warnings.
READY/AUTO
Indicates controller is in AUTO mode, ready for remote start signal.
SUPPLYING LOAD
Indicates the genset is running, giving proper voltage and frequency and
is supplying load.
ENGINE CONTROLLER FEATURES
ENGINE
ENGINE
START
START
ENGINE
ENGINE
STOP
STOP
MANUAL
AUTO
ALARM
CANCEL
FAULT
RESET
ALARM/FAULT
READY/MANUAL
READY/AUTO
WARNING
RUNNING
SUPPLYING LOAD
OPERATION
PAGE
SELECT
ENTER
DIAGNOSTICS
STATUS
CONTROL
CONTROL
ON
ON
CONTROL
CONTROL
OFF
OFF
MAN AUT
Ready
PF 0.00
RPM
0
0
kW 0
6
3
5
1
2
4
