- 7 -
7
SETTING UP THE MD INTERNET MEDIA TUNER
1.
Position the tuner away from any spot which may have extremes in
temperatures.
2.
Place the tuner on a very rigid surface capable of holding 75 pounds (34 KG).
3.
It is important that the tuner is not covered and it is not installed in a closed area
where there is little air circulation. Ensure at least 2” of clearance on the left and
right of the device, and 5” of clearance above the unit to allow for proper
ventilation.
4.
Connect the tuner to your preamplifier or integrated amplifier using a set of
cables consistent with the caliber of your system. Select the input you chose on
your preamplifier/Integrated. Note: Be sure that the preamplifier volume is set
to zero.
5.
If hardwiring your Wi Fi Tuner Plus, connect the Ethernet cable to the Ethernet
port, and the FM antenna cable to the RF input, on the back of the unit.
6.
Unwrap the EIA AC cord and plug the EIA end into the rear socket marked
Power
Input
. Plug the other end of the AC cord into a 120/220/230/240 volt
continuous AC power supply. Be sure that the voltage marked on the rear of the
unit is the same as the AC source that you are using.
7.
Press the power button on the front panel of the unit to the ON position, . The
screen will turn on displaying the Magnum Dynalab Logo as the MD 801 is
warming up.
8.
Go to the quick start page
** CHECK TO MAKE SURE THE UNIT IS SET UP FOR THE PROPER VOLTAGE **
(Check for unit’s voltage marked on rear panel) then plug the tuner’s AC power cord
into an AC power source. Be sure to use a continuous power source so as to allow
the stand-by mode feature to function properly. The tuner’s audio output is muted in
the stand-by mode.
