& Cruiser
03
INSTALLATION AND ADJUSTMENT
2
3
4
1
2. Installation And Adjustment
2.1 Handlebar and Stem Assembly
1. Remove the protective plug from the threaded stem.
2. Push the stem into the frame as shown in the image. Open the top cover, aligh the stem with the head tube and slide it
on. Tighten the screw at the top of the stem.
Tool you may need: 6mm Allen wrench.
3. Move the handlebar up or down to adjust to the desired angle, then tighten the rear-facing screw at the top of the stem
to lock the handlebar in place.
Tool you may need: 5mm Allen wrench.
4. Close the cover to complete installation and adjustment.
5mm
Screw for adjusting the
handlebar position
6mm
16-18N.m
Protective cover
The mark should always be
inside the head tube (inside the
frame, not visible)
