6-4
Installation
6.4.4 Step 4: Set the scanner DIL-switches
The DIL-switches are used for setting up of the scanner’s SCSI
connection ports, and for selection of the scanner test mode and the
scanner forced boot start up mode.
The DIL-switches are set from the factory to default settings that apply
to most common configurations so usually you will not have to change
them. Best scanning performance is obtained with only one device on
the SCSI bus. However, if your configuration requires more than one
device on the bus, you may need to change the DIL-switch settings.
The factory default DIL-switch settings and the DIL-stitch Value table
are shown on the following page. Use the table and the following
instructions for each switch to determine your DIL-switch settings if
you need to change them.
Before proceeding with setting the switches
you must turn the
scanner power off.
Removing and inserting the Smart Card (see
below) while power is on can damage the scanner.
