ASSEMBLY INSTRUCTIONS for Magnum Industrial Drill Press
MODEL:
MI-76390
Before you assemble your drill press, review the parts breakdown and keep it ready for
reference.
● Start by removing the parts from the packaging.
● Carefully check the packaging for small pieces before you continue.
● Lay out the parts on a large, clear and unobstructed area and ensure that all parts are
accounted for.
ASSEMBLING THE DRILL PRESS
1. Fasten the column (4) to the base (1) with the four bolts (3)
2. Remove the rack collar (16) from the column (6) by tapping and rotating it slowly
upwards.
3. Make sure the raising gears (10) (9) are in place. Insert the rack (5N) into the table
bracket (12) and lower these two pieces onto the column at the same time. This may
require two people or a forklift. The bottom of the rack (5N) slips into the slot provided on
the lower collar (124). The top of the rack (5N) is held in place by the rack collar (16).
Place the collar on the column and tighten the set screw (15).
4. Place the handle (7) on the worm gear shaft (9) and secure it with the hex head bolt (8)
5. Lower the main head onto the column and secure it with the set screws (20). This
requires at least two people.
6. Attach the three feed handles (14) and knobs (13).
Once assembled, clean the protective coating from all surfaces (where applicable) using a rag
dipped in kerosene, mineral spirits or paint thinner. (Dispose of potentially flammable
solvent-soaked rags according to manufacturer’s safety recommendations.)
A putty knife, held flat to avoid scratching the surface, may also be used to scrape off the
coating followed by clean-up with solvent.
Avoid rubbing painted surfaces, as many solvent-based products will remove paint.
INSTALLING THE CHUCK
1. Degrease all pieces.
2. Slide the arbor (121) into the spindle (102) flat end up.
3. Slide the chuck (120) over the tapered end of the arbor and, using a wooden mallet, give
the chuck a good tap. The taper is designed to hold the chuck securely in place.
If you have any questions or require further information, please contact KMS Tools Service
Department at 604.395.4134 or email [email protected]
