UNPACKING & INVENTORY
Check shipping carton and machine for damage before unpacking. Carefully remove packaging
materials, parts and machine from shipping carton. Always check for and remove protective shipping
materials around motors and moving parts. Lay out all parts on a clean work surface.
Remove any protective materials and coatings from all of the parts and the planer. The protective
coatings can be removed by spraying WD-40 on them and wiping it off with a soft cloth. This may
need to be redone several times before all of the protective coatings are removed completely.
After cleaning, apply a good quality paste wax to any unpainted surfaces including the infeed,
outfeed, and center tables. Make sure to buff out the wax before assembly.
Compare the items to inventory figures and verify that all items are accounted for. If at all possible,
retain shipping carton for warranty service if ever needed.
If any parts are missing, do not attempt to plug in the power cord and run the machine. The machine
should only be turned “ON” after all the parts have been obtained and installed correctly.
NOTE:
Some parts may have been installed at the factory. Please check before calling.
For missing parts, contact xxx.
1. DUST PORT
1 pc
2. HEX WRENCH 4mm x 100
1 pc
3. TORX WRENCH
1 pc
4. RAISE / LOWER HANDLE
1 pc
5. HEX SCREW M5*P0.8*20
1 pc
6. DUST PORT KNOB
2 pcs
1
2
3
4
5
6
Summary of Contents for MI-31170
Page 1: ...MODEL NO OPERATING MANUAL MI 31170 ...
Page 15: ...14 PARTS 97 ...
