CSW-RS Owner’s Guide
2
© 2013 Magnum Energy, Inc.
Mounting
CAUTION: Always check for hidden electrical wires, pipes, and
cables BEFORE drilling, cutting, or screwing into walls or cabi-
nets.
To mount the remote on a wall, the remote’s display panel will need to be
placed into an opening. This opening must have at least a 1” depth to allow
room for the remote’s rear switch and wires/cable.
1. Cut an opening in a wall – see Figure 3 to determine the correct opening
dimensions. DO NOT cut the opening too big. Ensure there are no openings
around the display, and that there is enough material for the screws to secure
the display. Remove any wall insulation (if applicable) that may contact the
back of the remote.
2. Route the remote cable thru the opening in the wall to the inverter location.
3. Position the remote into the opening in the wall and secure with two screws.
4. After ensuring the inverter is OFF, plug the remote cable into the Remote
port on the front of the inverter as shown in Figure 1.
Figure 3, Remote Switch Mounting
1 1/2"
36.7mm
1"
25.4mm
CUT THIS
AREA OUT
Remote cable
(routed in the wall)
CSW-RS
Face Plate
Ø3.8
2
"
(50.5 mm)
(53 mm)
1/8
2
"
1/2
2
"
(64 mm)
Figure 2, Remote Switch Face Plate Dimensions
