Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 141 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
5815,5001US / Version 02.66 141
Operating view

Main menu

Attachments

Boom contact settings
Parameters Description
Closing delay The parameters are only relevant in the following cases:
 The barrier is a "Swing Away" or "Auto Swing Away" design.
 In the "Close autom." parameter, the option is set to "Automatic".
If a car drives against a "Swing Away" barrier arm, it snaps from the flange. In
the "Swing Away" version, the barrier arm must be returned to the flange
manually. In the "Auto Swing Away" version, the barrier arm automatically
moves into the "open" position. When the position is reached, the barrier arm is
locked in the flange by springs.
After the barrier arm has caught again, the barrier closes after the time set
here.
Setting range
 0 to 10 s
Factory setting

10 s
Table 52: Menu "Boom contact settings"
10.11.3 Boom locking
The barrier can optionally be equipped with an electro-mechanical
boom lock at the end of the barrier arm. When the barrier is closed,
the boom locking is activated via the output function "Boom
locking". If a signal is present for opening, the boom lock is
released first.

Refer also to page 99, digital output function
"Boom locking".
Operating view

Main menu

Attachments

Boom locking
Parameters Description
Without boom locking
Boom locking not present.
With boom locking
Boom locking present.
Table 53: Menu "Boom locking"
10.12 Menu "Service"
This menu is only intended for MAGNETIC's service and only
accessible with a password.