Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 99 / 196

Barrier MHTM
TM
MicroDrive
Electrical connection
5815,5001US / Version 02.66 99
Function Description
Safety device The barrier can no longer be closed when +0 V DC are applied to this input.
If the barrier is just closing when the input signal changes to 0 V and the cut
off angle has not been undercut yet, the barrier will open again.
This input must only be used in addition to the internal detector module
or/and the safety light barriers connected to clamp X11. Only the internal
safety devices are monitored.
Acknowledgement
This input is required for parallel operation.

For more information on
parallel operation, see separate instructions.
1) The parameter is only sensible for the automatic program modes 5 to 8.
Table 26: Function "Digital inputs"
9.4.7 Digital outputs and output relays
Technical data

See page 41, chapter 4.5.
NOTE!
The digital output functions can be freely
parameterised for the following versions:
– Access Pro, Access Pro L, Access Pro H,
Access Select and Access Select L
– Parking Pro and Parking Select
For the remaining versions, the outputs are firmly
assigned.
→ For output parameterisation, refer to
page 105, chapter 10.
Factory setting
Clamp Description Function
DO1 Digital output 1 Boom release FB
(Boom release
feedback)
DO2 Digital output 2 Pulse after passage
DO3 Digital output 3 Signal light A
DO4 Digital output 4 Signal light B
NO1 Relay 1 Open
NO2 Relay 2 Closed
NO3 Relay 3 Error
NO4/NC4 Relay 4 Loop active A
NO5/NC5 Relay 5 Loop active B
NO6/NC6 Relay 6 Signal light C
Table 27: Factory settings "Digital outputs" and "Relay outputs"