Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 126 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
126 5815,5001US / Version 02.66
10.10.3 Cut off angle
Operating view

Main menu

Setup

Cut off angle
Parameters Description
Safety loop close This parameter serves to ensure that a closed barrier can not be opened
without authorisation.
Where the barrier arm is below the set angle for "Safety loop close" during
closing, signals of safety facilities like the safety loop or safety light barrier are
ignored. I.e., the barrier closes completely below the angle set here.
Setting range

Access: 1…40°
 Parking and Toll: 1…80°
Factory setting
 10°
Light barrier Where the barrier arm is below the set angle for "Light barrier" during closing,
the light barrier is ignored. I.e., the barrier closes completely below the angle
set here even if the light barrier is covered.
Setting range
 1 to 40°
Factory setting
 10°
Impact detection Where the barrier arm is below the set angle for impact detection during
closing, impact detection is deactivated. I.e., the barrier closes completely
below the angle set here.
Setting range
 1 to 40°
Factory setting
 10°
Table 44: Menu "Cut off angle"
10.10.4 Inputs

See page 97, chapter 9.4.6.
10.10.5 Outputs

See page 99, chapter 9.4.7.