71
mSwing
Installation and assembly
7.9
Adjusting the end stops
7.9.1
Explanations of mechanical end stops
The mechanical end stops "Left" and "Right" are set by 2 fixed end stops and
by 2 following end stops. A fixed end stop consists of a screw. A following end
stop consists of a square and 2 screws.
The fixed end stops are used for gross adjustment. The following end stops are
used for precise adjustment.
After the swing door is switched on, the left and right end stops are
approached to determine the angle of rotation. During operation the left and
right target position are approx. 3° away from the respective end stop.
ä
7.9.2
Adjusting the end stops
1. Adjust mechanical fixed end stops "Left" and "Right" using the screws.
ä
2. Install outer tube.
ä
3. Install blocking element.
ä
4. Turn the blocking element in the first desired target position manually.
5. Further turn the blocking element by hand for 3°.
6. Check that the blocking element is at least 50 mm away from solid walls
and objects in the end position.
7. Move the corresponding following end stop in the crescent until the
following end stop abuts against the inner stop screw.
8. Check that the cover plate completely covers the crescent. Turn the cover
plate if necessary.
9. Tighten the screws for the following end stop with 5 Nm.
10. Follow steps 4 to 9 for the second target position.
11. Perform reset
12. Set target positions on the MGC control unit or via mSwing Connect.
During the setting, observe the following points:
›
The mechanical end stops must be set at least 3° behind the respective
target position.
›
If you change the setting of the mechanical end stops, you must check the
target positions and reset them if necessary.
