SBP2 Pendant Pushbutton Stations Installation Instructions
June 2020
Page 8 of 26
1 Installing and Wiring the SBP2
®
Pendant Pushbutton
Station
1.1 Taking Precautions During Installation
•
Do not expose the unit to cold blasts of air that might cause
condensation (for example, an air conditioning duct).
•
Do not expose the unit to cleaning solvents that will penetrate and
damage the unit’s enclosure.
•
Do not use cable that is split or cracked.
•
Whenever possible, assemble the pendant in a vertical position to avoid
contaminates falling into the enclosure.
•
Attach the pushbutton station to the strain-relief cable so that no tension
forms on the pushbutton cable directly.
DANGER
HIGH VOLTAGES ARE PRESENT IN THE CONTROL PANEL, JUNCTION
BOXES, THE PENDANT’S ELECTRICAL COMPONENTS AND THE
CONNECTION BETWEEN THESE COMPONENTS.
Before installing, servicing or inspecting any electrical or mechanical
components of this power equipment, disconnect power at the source and
follow proper lockout/tagout procedures.
DO NOT make or break electrical connections (for example, plugs and
receptacles) without first disconnecting power at the source and following
proper lockout/tagout procedures.
REFER TO ANSI Z244.1 PERSONNEL PROTECTION – LOCKOUT/
TAGOUT OF ENERGY SOURCES.
Only qualified personnel should install components, inspect and/or service
this equipment.
SBP2 Pendant Pushbutton Stations Installation Instructions
June 2020
Page 21 of 26
11 Assembly Drawing