SBP2 Pendant Pushbutton Stations Installation Instructions
June 2020
Page 24 of 26
*Kit Includes nut, washer and six grommets.
Accessories Description
Catalog #
2-Position Selector Switch
SBP2-L2
3-Position Selector Switch N.C. in Center
SBP2-L3
3-Position Selector Switch N.O. in Center
SBP2-L3B
120-Volt Red Pilot Light-Mounts in Standard Button Hole
SBP2-PLX-R
120-Volt Green Pilot Light-Mounts in Standard Button Hole
SBP2-PLX-G
120-Volt White Pilot Light-Mounts in Standard Button Hole
SBP2-PLX-W
120-Volt Yellow Pilot Light-Mounts in Standard Button Hole
SBP2-PLX-Y
120-Volt Yellow Pilot Light-Mounts in Standard Button Hole
SBP2-PLX-Y
Red Mushroom On/Off Switch-Push/Pull SBP2-SMMH
Blank to Cover Button Hole
SBP2-BLNK
Cable Grip Kit*
CG-KIT
SBP2 Pendant Pushbutton Stations Installation Instructions
June 2020
Page 5 of 26
PREFACE AND SAFETY
©2020 MAGNETEK
All rights reserved. This notice applies to all copyrighted materials included with
this product, including, but not limited to, this manual. This manual is intended for
the sole use of the persons to whom it was provided, and any unauthorized
distribution of the manual or dispersal of its contents is strictly forbidden. This
manual may not be reproduced in whole or in part by any means whatsoever
without the expressed written permission of Magnetek.
PRODUCT SAFETY INFORMATION
Magnetek, Inc. (Magnetek) offers a broad range of radio remote control products,
control products and adjustable frequency drives, industrial braking systems, and
power delivery products for material handling applications. This manual has been
prepared by Magnetek to provide information and recommendations for the
installation, use, operation and service of Magnetek’s material handling products
and systems (Magnetek Products). Anyone who uses, operates, maintains,
services, installs or owns Magnetek Products should know, understand and follow
the instructions and safety recommendations in this manual for Magnetek Products.
The recommendations in this manual do not take precedence over any of the
following requirements relating to cranes, hoists, lifting devices or other equipment
which use or include Magnetek Products:
•
Instructions, manuals, and safety warnings of the manufacturers of the
equipment where the Magnetek Products are used,
•
Plant safety rules and procedures of the employers and the owners of
the facilities where the Magnetek Products are being used,
•
Regulations issued by the Occupational Health and Safety
Administration (OSHA),
•
Applicable local, state, provincial, or federal codes, ordinances,
standards and requirements, or
•
Safety standards and practices for the industries in which Magnetek
Products are used.
This manual does not include or address the specific instructions and safety
warnings of these manufacturers or any of the other requirements listed above. It
is the responsibility of the owners, users and operators of the Magnetek Products
to know, understand and follow all of these requirements. It is the responsibility of
the employer to make its employees aware of all of the above listed requirements
and to make certain that all operators are properly trained.
No one should use Magnetek Products prior to becoming familiar with and being
trained in these requirements and the instructions and safety recommendations
for this manual.