WARNING
Do not operate SBP2 Pendant Pushbutton Station unless you are fully trained
and qualified to operate the overhead material handling system of which this
SBP2 is a component. For applications other than overhead cranes or hoists,
consult Electromotive Systems at 1-800-288-8178.
Read the entire contents of this manual before you install or use the SBP2
Pendant Pushbutton Station.
CAUTION
Prior to installation, inspection, or repair of pendant station, disconnect power at
source following lockout/ tagout procedures as outlined in ANSI Z244.1.Read the
entire contents of this manual before you install or use the SBP2 Pendant
Pushbutton Station.
If the pendant cable grip is not properly sized to fit the pendant cable,
contamination of the pendant housing is possible. Contaminants which enter the
switch contacts may result in a potentially unsafe operating condition.
When cutting, stripping, and installing wires, ensure that contaminants do not fall
into the enclosure. Contaminants which enter the switch contacts may result in a
potentially unsafe operating condition.
Some pendant cable manufacturers add “talc” to their cable during the
manufacturing process. This “talc” can migrate from the cable into the housing of
the pendant station. As a result, contamination of switch contacts may occur
resulting in a potentially unsafe operating condition. Electromotive Systems
therefore recommends only the use of “talc” free cable for the wiring of all
pendant stations.
Remove all contaminants from the housing and switch contact areas prior to
sealing the enclosure and putting the pendant in service.
©2014 Magnetek
All rights reserved. This notice applies to all copyrighted material
included with this product, including, but not limited to, this manual and
any software embodied within the product. This manual is intended for
the sole use of the persons to whom it was provided, and any
unauthorized distribution of the manual or dispersal of its contents is
strictly forbidden. This manual may not be reproduced in whole or in
part by any means whatsoever without the expressed written permission
of Magnetek.
DISCLAIMER OF WARRANTY
Magnetek, hereafter referred to as Company, assumes no responsibility
for improper use of supplied product by untrained personnel. Product
should only be installed or repaired by a trained technician who has
read and understands the contents of this manual. Improper installation
or service can lead to unexpected, undesirable, or unsafe operation or
performance.
This may result in damage to equipment or personal injury. Company
shall not be liable for economic loss, property damage, or other
consequential damages or physical injury sustained by the purchaser or
by any third party as a result of such operation or service. Company
neither assumes nor authorizes any other person to assume for
Company any other liability in connection with the sales or use of this
product. For information on Magnetek’s product warranties by product
type, please visit www.magnetek.com.
