Flex 12EX2 Standard, AB and Tandem Instruction Manual
November 2017
Page 35 of 56
4.2.2.9 Pitch & Catch Function
This function allows two operators controlling from opposite ends of a crane or
equipment. When set to “Pitch & Catch” make sure the 2nd transmitter is set to the
next highest channel (channel X+1). For example, if the system is set to channel 01
then the newly added 2nd transmitter must be set to channel 02 with identical serial
number. Furthermore, the Channel dipswitch position #7 and #8 on the decoder
board must set to “10” for 2-channel scanning (scans channel 01 and 02). Refer to
on how to set to this
function. Pitch & Catch function must set to assigned channel scheme (
, part B).
4.2.2.10 Receiver Channel Scanning Function
Receiver channel scanning function is applicable only when a preset channel is
assigned to the system (
, part B).
(1)
→
“00” manufacturer preset (channel X)*
(2)
→
“01” scans 2 channels (channel X and channel X+1)
(3)
→
“10” scans 3 channels (channel X… channel X+2)
(4)
→
“11” scans 4 channels (channel X… channel X+3)**
* Channel X
→
channel set on the Channel dipswitch.
** Contact Magnetek field service if your application requires scan
-
ning more than 4 channels.
Example:
If the first 6 dipswitch positions are set to channel 01 (000001), when set to
2-channel scanning (type 2 above) the receiver will scan only channel 01 and 02.
4
1
3
2
6
5
8
7
4
1
3
2
6
5
8
7
4
2 3
1
7 8
5 6
4
1 2 3
6
5
7 8
