Enrange CAN-6 Instruction Manual
September 2011
Page 20 of 24
5.0 NORMAL
OPERATION
During normal operation the CAN-6 receiver will receive commands from the transmitter
and convert them to output or CAN signals. During these operations, the operator can
verify that the receiver is online and functioning by interpreting the status LED light pairs
on the front of the CAN-6 receiver. If there are errors during operation, the LED lights
can help troubleshoot the problem.
5.1 INITIALIZATION
During startup of the CAN-6 module after power is applied, the signal strength/error code
LED will illuminate to provide initialization status.
Solid Green = Initialization ok, no errors present
Solid Red = Start up initialization error
After initialization is complete, the LED will then illuminate the signal strength and error
code status as part of the normal operation.
5.2 NORMAL
OPERATION
During normal operation of the receiver, the receiver will receive commands from the
transmitter and convert them into outputs or CAN messages. During the operations, the
receiver will communicate its status via LEDs.
5.3
LED STATUS INDICATION
The CAN-6 has two LEDs for indicating the CAN-6 status at a glance during normal operation.
The bottom LED indicates the CAN-6’s signal strength/error codes, while the top LED indicates
sending or receiving of messages.
5.3.1 RF Messages LED (Top LED on CAN-6 Faceplate)
Green Slow Blinks - Transmitter is offline (watchdog indicator)
Green Fast Blinks - Each blink is a valid RF message
Red Blinks - Internal boot-up sequence
Red Solid - Error occurred, refer to Error Code LED's blink code
WARNING
DO NOT ASSUME THE POWER IS OFF IN THE RECEIVER BECAUSE THE
TRANSMITTER IS TURNED OFF. FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
