Magnavox W-08CR, Owner'S Manual, Page: 12 / 19

C: Align the hole in the top rail with those in the
top of the unit as shown in Fig.F
Fig.F
Fig.G
D: Secure the top rail to the unit with the 3/8
Screws as shown in Fig.G.
NOTE: For safety reasons, all four(4) screws
MUST be securely fastened.
,,
HOW TO INSTALL
NOTE: Top rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of
(5/16 ). This is necessary for proper condensed water utilization and drainage. If you are
not using the Side Panels for any reason, this pitch to the rear must be maintained by other
,,
11
means.
1
A. Hold the side Panel in one hand
and gently pull back the center to
free the open end. See Fig.1.
B. Slide the free end " " section of the panel
directly into the cabinet as shown in Fig. 2.
Slide the panel down. Be sure to leave enough
space to slip the top and bottom of the frame
into the rails on the cabinet.
Fig.1
Fig.2
" "section
Place unit on floor, a bench or a table. There is a
Left and Right side Filler Panels- be sure to use the
proper panel for each side. When installed, the flange
for securing the panel in place to the window sill will
be facing into the room.
C. Once the panel has been installed on the side of
the cabinet, make sure it sits securely inside the
frame channel by making slight adjustments.
Slide the top and bottom ends of the frame into the
top and bottom rails of the cabinet. Fig.3.
D. Slide the panel all the way in and repeat on the
other side.
NOTE: If storm window blocks AC, see Fig. 10.
Top Rail
Bottom Rail
Fig.3