Step 1:
The radio chassis is designed to be “Sleeve
Mounted” through a opening in the dashboard panel.
The required opening size is 182mm (7-3/16”) x
53mm (2-1/16”). Cut or enlarged an opening in the
dashboard to accommodate the mounting sleeve.
Step 2:
Insert the mounting sleeve into the hole
in the dashboard. Bend the metal tabs on the sleeve
to secure the mounting sleeve to the dashboard.
Step 3:
Bring all wiring for the connection of the
unit (including the antenna) through the center of the
mounting sleeve. Connect the wiring as follows:
Yellow Wire: Connect this wire to a co12
volt power source (a power source that is not
controlled by the ignition key).
Red Wire: Connect this wire to a switched +12
volt power source (a power source turned on and
off by the ignition key).
Blue Wire: Connect this wire to the (+) power
antenna activation circuit or remote amplifier
activation. If no power antenna or amplifier exists,
tape-off the end of this wire to prevent shorting
out the unit.
Black Wire: Connect this wire to the frame of the
vehicle (ground). This wire is the chassis ground-
ing wire for the unit.
White Wire: Connect this wire to the Left Front
Speaker (+) positive terminal or wire.
White Wire with Black Stripe: Connect this wire to
the Left Front Speaker (-) negative terminal or wire.
Green Wire with Black Stripe: Connect this wire to
the Left Rear Speaker (-) negative terminal or wire.
Green Wire: Connect this wire to the Left Rear
Speaker (+) positive terminal or wire.
Gray Wire: Connect this wire to the Right Front
Speaker (+) positive terminal or wire.
Gray Wire with Black Stripe: Connect this wire to
the Right Front Speaker (-) negative terminal or wire.
Violet Wire with Black Stripe: Connect this wire to
the Right Rear Speaker (-) negative terminal or wire.
Violet Wire: Connect this wire to the Right Rear
Speaker (+) positive terminal or wire.
Red/White RCA Connectors: Provides Left and
Right Channel audio signal output for input to an
additional amplifier.
Note 1: This unit is designed to connect to (4)
four speakers. If the installation only requires (2)
two speakers, use the White and Gray wire sets to
connect the speakers.
Note 2: If installation angle exceeds 30 degrees
from horizontal, the unit might not give its opti-
mum performance.
Note 3: Avoid installing the unit where it would
be subject to high temperature, such as from
direct sunlight, or from hot air, from the heater, or
where is would be subject to dust, dirt or exces-
sive vibration.
Step 4:
Finally place the trim ring over the unit.
12
Installation Procedures
WARNING!
Any wires left unconnected must be taped-off
or capped-off to prevent shorting.
DO NOT connect speaker ground wires together.
DO NOT connect speaker ground wires to the
chassis of the vehicle.
DO NOT connect front and rear speaker wires
together.
FAILURE TO FOLLOW ANY OF THESE
WARNINGS WILL RESULT IN DAMAGE TO
THIS UNIT AND VOIDS THE WARRANTY.
Remove Transportation Screws: Before installing
the unit, please remove the two screws shown in
the illustration below.
Remove Transportation
Screws Before
Installation
