EN
10
www.magmaweld.com
USER MANUAL | KULLANIM KILAVUZU
MGA 800
2.1 Wheel Guard Installation
2.2 Disc Grinding Wheel Assembly
OPERATION
Loosen the fastening screws on the guard, position guard on spindle neck so
that the notches on guard line up with the keys on the spindle neck. Then fasten
the screw tightly.
When you need to adjust the angle of the guard, you should slightly loosen the
screw and rotate guard to desired angle, and then tighten the fastening screws
again.
Be sure the power is disconnected before installing or removing wheel guard.
Placing
BACKING FLANGE
and
GRINDING WHEEL
on the
spindle, then thread on the
LOCK NUT
and tighten
NUT
by
wrench while pressing down the
SELF-LOCK DEVICE
to hold
the spindle lock in.
TO REMOVE
: Reverse procedure.
Be sure the power is disconnected before installing or removing wheel guard.
SCREW
GRINDING WHEEL
LOCK NUT
SPINDLE
BACKING FLANGE
SELF-LOCK
DEVICE
2.3 Switch Operation
After switching off, the appliance continued to run on for a few seconds. Wait
until the abrading disc has come to a stop before laying the appliance down.
1.
Set the On/Off switch to position
(1)
to switch the appliance on.
2.
Set the On/Off switch to position
(0)
to switch the appliance off.
Be sure the self-lock device is free before using the appliance.
ON
OFF
SWITCH
Operation