Magmaweld ID 300E, User Manual

Page: 15 / 72

EN
15
www.magmaweld.com
ID 300E
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
2.3 Mains Plug Connection
2.4 Connections for MMA Welding
2.5 Connections for Touch-Scratch TIG Welding
For your safety, never use the mains cable of the machine without a plug.
• Since mains connection sockets may vary from factory to
factory, an appropriate plug must be installed o the builtin
mains cable of the machine by qualified electricians. Please
observe that the earth cable is in yellow/green colour and
labeled as .
• After installing the electric plug, DO NOT INSERT IT INTO THE
SOCKET AT THIS STAGE.
• According to the polarity of the electrode to be used, insert
welding cables into the appropriate outlet and tighten them
by turning clockwise.
• Connect the earth clamp tightly to the workpiece as close as
possible to the welding area.
• TIG torch with a valve should be used.
• Connect the TIG torch power cable to the negative outlet and
the earth cable to the positive outlet of the machine.
• Install the argon gas regulator onto the argon gas cylinder.
• Connect the gaz hose of torch to the gas regulator.
Figure 2 : Electric Plug Connection
Figure 3 : MMA Welding Connections
Figure 5 : TIG Welding Connections
Figure 4 : TIG Welding Connections
Diameter of
Electrode
(mm)
Diameter of
Nozzle
(mm)
Welding
Current
(ADC)
Gas
Debit
(lt/min)
1.0
1.6 6.3
9.5 15-70
30-150
6-8
6-8
Installation