Magma EOwave, Owner'S Manual

Page: 11 / 23

20 21
4. PROGRAMMING SECTION
4. PROGRAMMING SECTION
all the ”white keys”. By turning the VALUE encoder, you select a note. To access the ”black keys”, simply
observe the LED readout when turning the value encoder: A dark LED between two illuminated steps (e.g.
between ”C” and ”D”) means, a ”sharp C”/”C#” is programmed.
When turning the value encoder a bit further, you may notice that the LED in the lower row also changes.
The lower row displays the octave setting of the selected note.
Carry on programming all desired notes in the same way until you have created a nice sequence. Rest
assured that, if it pleases you, it will please us (and others) as well.
4.2.4. Mod tracks
We mentioned this at the beginning of this section: The three other tracks provide control over MAGMA´s
sound parameters. They dynamically change value settings of assigned parameters. To program these
tracks, please
• Hit SHIFT (hold) + M DEST to enter the mod destination function.
• Hit START/STOP to start the sequencer.
• Hit M1 to select the desired mod track.
• Hit a STEP to select it and keep it depressed while moving the desired PARAMETER knob.
This value will be stored in the selected step.
Hit more steps and program alternative parameter values into them.
To program another mod track, please
• Hit again SHIFT (hold) + M DEST to assign a new modulation destination (see above).
• Hit M2 to select the second mod track.
TRANSP A SHUFFLE B SWING RST
+
hold
TRANSP A SHUFFLE B SWING RST
+
hold
hold hold
hold
+
+
+ +
hold
+
TRANSP A SHUFFLE B SWING RST
Parameter-
Value
TRANSP A
SHUFFLE B SWING RST
TRANSP A SHUFFLE B SWING RST