SETTING UP YOUR GRILL
3
Mounts sold separately. See our website www.MagmaProducts.com for mounting options.
Burner Ground Strap
Grease Tray
Grease Tray Pins
Electrode
5
With grill body tightly attached to L-Bracket and taking care not to damage electrode, unthread
burner
3 full revolutions only. CAUTION: DO NOT UNTHREAD MORE THEN 3
REVOLUTIONS, AS GRILL MAY FALL OVERBOARD.
• Lift entire grill up to disengage from grease tray positioning pins
(5a & 5b)
and rotate so lid
operates freely in desired position
(5a)
.
• Carefully lower back down
(5d)
, making sure pins are re-engaged and rethreaded “burner” back
3 revolutions until tight. If burner does not turn 3 revolutions the pins are not engaged properly.
6
Adjust burner ground strap so it is directly over electrode wire. Check for spark before proceeding.
1
Select and install appropriate Magma mount in your desired location. Prior to installing the grill,
check that mount does not easily move with a reasonable force applied.
2
Next, decide if gas control valve will be easier to access from the center right side or center left
side of grill. This will be based on your placement of the mount
(see picture front cover)
. Now,
slide L-Bracket & Clamp on to mount knurled rod so that the threaded flat L-portion of the L-Bracket
points in that direction.
3
Adjust threaded flat surface of L-Bracket to level position and tighten firmly with 9/16" or
adjustable wrench so that L-Bracket & Clamp cannot be moved. NOTE: Level positioning is critical
for even temperatures across the cooking surface.
4
Carefully hold the grill body, with the lid closed, and thread on to L-Bracket
VERY TIGHT
so that
grill does not unthread easily. Check that grill is tight and level prior to proceeding.
Level
Flat
Surface
1
3
4
5a
5
5b
5c
6
5d
2
Threaded Burner Pipe
Electrode
