Magliner LiftPlus, Owner'S Manual

Page: 13 / 20

1-800-MAGLINE (624-5463) www.magliner.com
Lift Plus
®
13
Maintenance
Area
Inspection
Frequency
Procedure/Normal Condition
Outside Surfaces Daily
Keep clean and dry. Replace any cracked or missing
covers.
Fasteners Daily Tighten any loose hardware.
Battery Charging Daily Green charging light should turn on when charging.
Rear Wheels Daily Inspect wheels and tires for wear and cracks.
Front Casters Daily Inspect for wear; clean dirt and debris.
Rolling Function Daily
Unit should roll easily in all directions: forward/back-
ward and left/right.
Brake Lever Daily
Brake lever should move freely up and down; lock lever
should hold brake lever in locked (squeezed) position.
Brake Tension Daily
Braking power should be sufficient; if not, adjust as
necessary (see Brakes section). To test - squeeze the
brake lever tightly, tilt the unit back about 35° and try
to push the unit. Wheels should not spin when holding
the brakes tightly.
It is normal for brakes to rub slightly, but it should not
be enough to interfere with easy rolling of the unit.
Trolley Daily
Inspect for wear or damage. Trolley should move up
and down smoothly within the lift assembly.
Lift Screw Daily
Inspect before each use; keep free of dirt and debris.
Lifting and lowering motions should be smooth.
Attachments/
Accessories
Daily Inspect for wear and damage; replace as needed.
Folding Linkage
Assembly
Weekly
The unit should fold and unfold smoothly. Locking latch
should fully lock into place; see section Unfolding the
Unit for photos.
Battery Connections Weekly
Tighten any loose connections to the battery terminals.
Check for any cracked or damaged wires; replace parts
as needed.
Lift Screw
Lubrication
Weekly for first month;
Monthly after first
month.
Lubricate with a plastic-safe multi-purpose precision
lubricant such as CRC Industrial Technical Grade 3-36.
1. Place absorbent towel underneath the unit.
2. Spray length of lift screw, the center trolley surface,
and front and rear plastic wheel shafts (see next
page for diagram). It does not need to be soaked,
just enough so it spreads on the surfaces.
3. Lift and lower unloaded attachment for 5 full cycles
to distribute lubricant.