Magio MG-892, Instruction Manual

Page: 23 / 28

21
- wet dust and dirt;
- water and other liquids.
• Do not vacuum people or pets.
• Do not pull the vacuum cleaner by the flexible hose. Check his condition regularly. Do not use the hose if it is
damaged.
• Do not block the air outlet of the vacuum cleaner.
• Do not install the vacuum cleaner on the edges and sides of the body. The vacuum cleaner should always be in a
horizontal position, watch for the stability of the vacuum cleaner on the stairs.
• Do not switch the appliance on if any of its openings are blocked.
• Keep hair, free hanging clothes, fingers and other parts of your body away from the vacuum cleaner air inlets.
• Do not use the vacuum cleaner if:
- the dirt container is not installed or installed improperly;
- the filters are not installed or installed improperly.
Sphere of use
The appliance is intended for cleaning domestic premises by sucking in dust and small debris.
Unpacking and assembly
After transporting or storing the appliance at a low temperature, keep it at room temperature for
at least three hours.
1. Check the integrity of the appliance; if damaged, do not use the appliance.
2. Remove any stickers and packing materials that interfere with the operation of the appliance.
Before using for the first time
1. Connect the hose to the body by inserting the hose into the air intake opening until you hear
a click. (pic.1) To disconnect the hose, disconnect the device from the mains, press the button on
the branche pipe and remove the hose.
2. Insert the hose handle tip into the fixed part of the telescopic tube. (pic.2)
3. Slide forward (from yourself) the plastic retainer on the fixed part of the telescopic tube and
pull out the part that is extended to the required length. Adjust the length of the telescopic tube.
(pic.3)
4. Attach the desired attachment to the part of the extending telescopic tube (floor/ carpet large
brush or one of the additional nozzles). (pic.4)
5. Preparation of brush for cleaning carpets, tile, wooden coverings:
6. Rigid coatings - bristles launched. (pic.5)
7. Carpets - bristles hidden. (pic.6)
8. Combined nozzles for cleaning curtains, upholstery of furniture, inaccessible places. (pic.7)
Operating procedure
1. Unreel the cord and plug into an outlet.
Do not unwind the power cord after the yellow mark, which signals the end of the unwinding
cord is approaching. A red mark indicates the end of the unwinding cord.
2. To turn on the appliance, press the ON/OFF button on the vacuum cleaner body.
3. When finished, turn off the vacuum cleaner using the on/off button on the body, then unplug the
appliance.
4. Wind the cable, by pressing the button for automatic winding of the cord. Point the cable so that
it winding evenly to the receiver.
Note
During the operation you can control the suction power using the power control and the
manual suction power control on the flexible hose handle.
EN