Magio MG-449, Instruction Manual, Page: 20 / 22

20
EN
Before first use
Brewing coffee
not put your hands in the water. Before further use, the appliance must
be checked by a qualified specialist.
• For the safety of children, do not leave a plastic package that are used
as packaging unattended.
• Protect the device from falls and hits.
• Do not allow children to touch the housing of the appliance and power
cord while the device is operating.
• During operation and in between work cycles, place the device out of
the reach of children.
• Always unplug the appliance when unattended and before assembling,
disassembling or cleaning.
• Surfaces with marking (page 22) heat up during use.
After transportation or storing the device at a low temperature, keep it
at room temperature for three hours at least.
1. Unpack the unit completely and remove any stickers that can
prevent unit operation.
2. Check the unit for damages; do not use it in case of damages.
3. Before switching the unit on, make sure that your home mains
voltage corresponds to the unit operating voltage.
4. Wash the thermal mug (9), filter (6), all removable parts with water
and a neutral detergent, rinse thoroughly and dry. Wipe the body (3)
with a clean, damp cloth.
5. Dry all parts of the appliance and carry out a full brewing cycle in
accordance with the section «Brewing coffee» without filling coffee
in the filter.
The ready coffee drink is made by one-time passing of hot water
through a layer of ground coffee in the filter.
1. Place the appliance on a flat, stable surface.
2. Open the lid of the water tank (1).
3. Fill the thermal mug (9) with clean drinking water, then transfer the
water from the mug to the water tank (2). The water level should not
be higher than the mark «14 oz» (
~
420 ml) indicated inside the tank.
4. Place the filter in the filter holder and the filter holder in the chamber
(8) (see page 3).
5. Measure out the required amount of ground coffee, put it in the filter
and close the lid.
6. Place the thermal mug on the platform (10) under the coffee outlet
spout. Use a thermal mug without a lid.
7. After making sure that the power supply parameters match the data
Attention! Do not allow children to play with plastic bags or
packaging film. Danger of suffocation!