Magio MG-349, Instruction Manual

Page: 20 / 24

20
EN
1. Unwind the power cord completely.
2. Wipe the coffee bowl, body with a slightly damp cloth, and then wipe
them dry.
3. Wash the flask with warm water and a neutral detergent, rinse and dry
it thoroughly.
4. Place coffee maker on a firm, flat surface.
5. Before preparing coffee brewing spend 2-3 cycles using only water
without falling asleep coffee to the coffee filter.
6. Open the lid (1) and pour water into the reservoir, but not above the
MAX mark, install the flask (6) on the platform (7), insert the power
cord plug into the socket, and turn on the coffee maker by setting the
power switch (3) to the «I» position.
7. After there is no water left in the tank, turn off the coffee maker by
setting the switch (3) to the position (0).
• If the appliance falls into water, unplug it immediately. In this case, do not
put your hands in the water. Before further use, the appliance must be
checked by a qualified specialist.
• For the safety of children, do not leave a plastic package that are used
as packaging unattended.
• Use the accessories recommended by the manufacturer only.
• Protect the device from falls and hits.
• Do not allow children to touch the housing of the appliance and power
cord while the device is operating.
• During operation and in between work cycles, place the device out of
the reach of children.
• Always unplug the appliance when unattended and before assembling,
disassembling or cleaning.
• Surfaces with marking (page 23) heat up during use.
Attention! Do not allow children to play with plastic bags or
packaging film. Danger of suffocation!
Warning! To improve the quality of the taste of coffee always before
every first cooking, «run away» coffee maker without coffee!
Unpacking
Before first use
After unit transportation or storage at low temperature keep it for
at least three hours at room temperature before switching on.
1. Unpack the unit completely and remove any stickers that can prevent
unit operation.
2. Check the unit for damages; do not use it in case of damages.
3. Before switching the unit on, make sure that your home mains voltage
corresponds to the unit operating voltage.