AFTER SALES SUPPORT
AFTER SALES SUPPORT
AUS
1 800 623 432
AUS
1 800 623 432
15
AUS
AUS
14
Use
Use
Use
Installation of camera
The camera must be mounted to the rear end of your vehicle.
The mount is designed to be fixed with the screws of your
license plate. However the camera can also be mounted in a
different position with two screws.
Mount the camera to a position which will ensure a clear view
behind you. Furthermore please ensure a secure cable route
as well.
Screw the base of the mount to the surface with the supplied
screws. Bear in mind that the “UP” marked side of the camera
is pointing upwards. Now install the cables to the designated
position.
Connection of camera
To supply your camera with power it must be connected
to the connecting cable of your vehicle´s reversing lights.
The camera is then activated every time the reverse gear is
selected.
Camera
Connector
Transmitter box
Antenna
Red LED
Power cable
red
black
Reverse
lamp
Wire clamp
Wire clamp
Connect the red camera cable to the positive cable of the
reversing lights and the black cable to the negative cable. The
positive cable is normally coloured, whilst the negative cable
is generally black. For absolute certainty the correct cables
should, however, be determined by measuring or checking
with the manufacturer.
Ensure that the cables are accurately connected and
insulate the connecting points to prevent bad contacts and
shortcircuiting!
Remove license plate screws
Attach camera with license plate screws