Technical Service Manual
MKG Series Gas Griddles
Page 8
L22-296 Rev 0 (4/08)
Photo 9
Photo 10
Photo 11
Photo 12
Photo 13
•
See Photo 10, Using needle nose pliers,
carefully disconnect the Piezo ignition wire(A),
from the Piezo ignitor assembly(B). The upper
panel is now disassembled from the appliance.
4.1.2
Matchless Series (E & ST)
•
Remove lower panel(A) by removing four (4)
10-24 truss head screws(B) from the inner
flanges, See Photo 11.
•
Remove grease box(s),(C) from cabinet to
allow access to the front panel clip in the
grease box compartment.
•
Release the panel clip from the grease box
compartment by twisting the clip out of the slot
in the roof of the compartment, See Photo 12.
•
Pull lower panel away from front of appliance,
this will give access to the gas valves, ignition
modules, and temperature controls.
•
To remove the upper switch panel, remove the
#10 self threading screws,(B in Photo 9),
similar to those of the snap action panel. This
will give access to the burner manifolds.
•
Remove the temperature control mounting
panel by removing the four (4) 10-24 truss
head screws, see photo 13.
Important!
Carefully support component panels so wiring
connections will not be strained. Failure to
comply may cause wiring damage
.
•
Disconnect all wiring harness’ and place both
the switch panel, and the control panel in a
safe location so they will not become
damaged.
•
Once both panels have been disassembled
from the unit there will be complete access
from the front of the appliance for all the
electrical components.
