MAINTENANCE AND REPAIRS
REVISIONE: X51-1213 EN
28
MAGIDO GROUP S.r.l.
Verify that these controls are carried out when the machine is switched off from all the power supply.
In particularly verify that all parts are in their place in the correct position and there are not any lose parts.
General cleaning of the machine
Verify daily the state of the machine and in particularly the nozzles and the cylindrical filters. Clean the
whenever necessary.
Clean any eventual scale from the level probes, if the machine is equipped with this.In the case of the water
becoming dirty very quickly change the water more often.
Visual control of the water
Control the water level daily , top up to normal level if necessary.
Water change
Change the water when necessary as follows:
Place a container underneath the drain tap;
Open the drain tap located under the machine until it has completely emptied;
Close the drain tap.
N.B. : change the water less frequently if the machine is only use sporadically
Dirty water will quickly cause the pump seal to wear out, resulting in leaking water.
All machine cleaning operations must be carried out with suitable protective gloves and
eyewear.
Do notwash the machine using direct jets of water, liquids or corrosives, solvents or
benzine. Clean the machine and electrical components using a cloth slightly moistened
with a mild detergent solution.
It is absolutely forbidden to drain the wash liquid to the environment or sewer. Follow
scrupulously the local regulation concerning waste treatment
Drainage tap