MAGICO Q7 User’s Guide
© 2013 MAGICO LLC
10
STEP 5:
One person man each of the lift extensions/foot brackets with a 3/8” drive
socket wrench and 15mm 12 point bit. Work together to counting out sets of 10 x 180
degree cranks. This is to ensure that the loud-speaker cabinet is lifted on a level plane.
Always make sure that as lift is being cranked that the bearing is moving in concert with
the bolt. Always make sure that the foot is not turning with the bearing, as this will
damage the foot and the floor.
NOTE:
It is important to take a step back after every (3)
sets of (10) 180 degree cranks to ensure that the loud-speaker is still level with the floor.
If not, jack the appropriate side to compensate.
STEP 6:
Once the Jacking bolt heads bottom out against the Q7 lift foot brackets,
remove the caster and replace each with a Q7 foot assembly. Before the Q7 foot
assemblies are installed, the two pieces should be separated so there is approximately
¼
”
of space between the base and top piece.
NOTE:
This can be adjusted after the loud-
speaker is lowered with the supplied spanners in the accessory kit.
STEP 7:
Reverse steps (5-1) to remove the lift from below the loud-speaker cabinet.
WARNING/DISCLAIMER:
•
Never place hands underneath speaker without someone holding the speaker
steady. There should always be a spotter who is not actually helping lift the
speaker.
•
Never attempt to tilt speaker by hand.
•
Never crank the bolts at a speed that rocks the speaker, with gentle cranks the
speaker will rise smoothly and safely.