MAGICFX
®
STADIUMBLASTER
—
User and Installation Manual
25
3.7
SETUP MULTIPLE MACHINES IN A SEQUENCE WITH DMX
PowerCon TRUE1 female
5-pole female
PowerCon TRUE1 male
5-pole male
POWER
DMX
POWER IN
POWER OUT
DMX IN
DMX OUT
POWER IN
POWER OUT
DMX IN
DMX OUT
1.
Connect a power link cable to the power output.
2.
Connect the other end to the power input of the next machine.
3.
Connect a DMX cable to the DMX output.
4.
Connect the other end to the DMX input of the next machine.
5.
Use the buttons or a RDM controller to assign DMX addresses, see chapter 1.
6.
Repeat step 1 to 5 for each subsequent machine.
CAUTION
Always plug in a DMX Terminator into the DMX output of the final
unit in the control sequence. Using a DMX Terminator improves
signal reliability.
3.8
BLAST WITH DMX
1.
Make sure that each safety zone is free from persons and hazardous objects.
2.
Activate the Safety address. The FX LED indicator on each machine lights up.
3.
When it’s time to blast, activate the Start address.
NOTICE
The best effect results are achieved when you open the lid just
before you start blasting. Make sure that no foreign objects will
enter the hopper and close the lid again after the effect.
4.
Enjoy the view!
5.
Deactivate the Start address when the hopper is out of confetti.
