Magicar M881A, User Manual

Page: 53 / 76

53
EN EN EN EN
7.3. Setup of security code
Conditions for primary setup of security code!
Function in Programming menu 1-04 must be set.
Disarmed ignition on / Doors opened
engine off
Programming of security code (1111-9999):
1. Ignition on.
2. Open the door.
3. Push the button on RPS sensor 10 times. At every single push, LED will flash red.
Intervals in-between the pushes must not be longer than 1.5 sec.
4.
LED will start flashing fast blue. If this is not happening, go back to step 1
.
5. Push the button on RPS as many times as your first number between 1-9 is. After each
push, red LED will flash.
6. After entering the digit, wait until led will confirm the digit by a corresponding number of
blue LED flashes.
7. Blue LED will begin flashing fast. Push the button on RPS as many times as your
second number between 1-9 is. After each push, red LED will flash once.
8. After entering the digit, wait until led will confirm the digit by a corresponding number of
blue LED flashes.
9. Repeat steps 7, 8 for entering the third and fourth number of your code.
10. After entering the fourth number, lights will flash to confirm acceptation of the
programmed code.
7.4. Disarming (using security code):
1. Knock on RPS 10 times.
2. At each knock LED will flash red once. Intervals between each knocks must not be
longer than 1.5 sec.
3. LED will start flashing blue fast.
4. Enter your 4-digit code by knocking correspondent
number between 1-9. After each knock LED will flash
red once. Intervals between each knocks must not be
longer than 1,5 sec. After entering each digit, wait
until LED confirms the number by a corresponding number of blue LED flashes. If LED
confirms the correct knock number and starts flashing quickly again, continue by
entering remaining three digits. If there is a wrong number entered, the remote control
will start beeping and vibrating (4x). Then go back to step 1.
5. After entering the correct code the doors will unlock, the car alarm will disarm which will
be displayed on remote, too.
Note
If you enter the wrong password more than 5 times within 30 min, this function will not be
available for 24 hours or until the car is unlocked by the remote control.
Attention!
There is no code programmed in the alarm by a manufacturer. We recommend you set your own code
immediately after taking your car from the garage!