Magic Chef MCR32CHW, User Manual

Page: 7 / 28

4
INSTALLATION INSTRUCTIONS
Before Using Your Refrigerator
• Re m o v e the e x terior and interior packing.
• B efore connecting the refrigerator to the power source, let it stand upright for appro x i m ately 4 hours.
This will reduce the possibility of a m alfunction in the cooling syste m fro m i m proper handling during
transportation.
• Cl ean the interior surface with lukewar m water using a soft cloth. ( C leaning instruction on page 7)
Installing Your Refrigerator
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully
loaded.
• Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper air
v entilation. Adjust the feet to keep the refrigerator le v el.
• L ocate the refrigerator away fro m direct sunlight and sources of heat (sto v e, heater, radiator, etc.).
Direct sunlight m ay affect the acrylic coating and heat sources m ay increase electrical consu m ption.
A mbie nt te mpe rature below 50°F or abo ve 85°F will hinder the perf orma nce of this appliance. This
unit is not designed for use in a garage or any other outside installation.
• A v oid locating the refrigerator in m oist areas.
• Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not under any
circu m stances cut or re m o v e the third (ground) prong fro m the power cord. Any q uestions concerning
power and/or grounding should be directed toward a certified electrician or an authorized ser v ice
center. This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for 2~3
hours under before placing food in the refrigerat .r o
Handle Install Instruction
Please note that the Handle parts are inseparable once joined. Please ensure that the handle
base is screwed firmly on the door before joining the actual handle part onto its base.
1. Take out the handle from the unit and remove the package.
2. Push the handle horizontally until it clicks in.
3. Push and pull the handle to make sure that it is installed completely.