CARE AND MAINTENANCE
Cleaning Your Refrigerator
•
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
•
Turn off the refrigerator first and then unplug the unit from the wall outlet.
•
Remove all food content.
•
Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution.
The solution should be about 2 tablespoons of baking soda to a quart of water.
•
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
•
The outside of the refrigerator should be cleaned with mild detergent and warm water.
•
Dry the interior and exterior with a soft cloth.
Vacation Time
•
Use extreme caution in the case of children. The unit should not be accessible to child’s play.
•
Short vacations:
Leave the refrigerator operating during vacations of less than three weeks.
•
Long vacations:
If the appliance will not be used for several months, remove all food and unplug
the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave
the door open slightly: blocking it open if necessary or have the door removed.
Moving Your Refrigerator
•
Turn off the refrigerator first and then unplug the unit from the wall outlet.
•
Remove all the food.
•
Securely tape down all loose items inside your refrigerator.
•
Tape the doors shut.
•
Be sure the refrigerator stays in the upright position during transportation.
Energy Saving Tips
•
The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
•
Let hot foods cool to room temperature before placing in the refrigerator. Overloading the
refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose quality, or
spoil.
•
Be sure to wrap foods properly, and wipe containers dry before placing them in the refrigerator.
This cuts down on frost build-up inside the refrigerator.
•
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Light Replacement
•
Changing the lamp as following:
•
Disconnect the power.
•
Remove the transparent lamp cover.
•
Remove and change the lamp
•
Replace the lamp cover.
•
Never fit a lamp with a higher wattage rating than that stated above.
•
The voltage (V) marked on the lamp must always correspond to that shown on the appliance
rating plate.
7
