SPECIFICATIONS
TROUBLESHOOTING
Pressure:
5°C-40°C within±3mmHg(0.4kPa)
Pulse value:±5%
Rated cuff pressure:
0mmHg~299mmHg(0kPa ~ 39.9kPa)
Measurement pressure:
SYS: 60mmHg~230mmHg (8.0kPa~30.7kPa)
DIA: 40mmHg~130mmHg (5.3kPa~17.3kPa)
Pulse value: (40-199)beat/minute
Power supply
Display mode
Measurement mode
Oscillographic testing mode
Measurement range
Accuracy
Working condition
Storage & transportation
condition
Measurement perimeter
of the upper arm
About 22cm~32cm
Weight
Approx.260g(Excluding the batteries)
External dimensions
Attachment
Mode of operation
Continuous operation
Degree of protection
Type BF applied part
IP Classification
WARNING: No modification of this equipment is allowed.
Software Version
A01
Device Classification
Battery Powered Mode:
Internally Powered ME Equipment
AC Adaptor Powered Mode: Class II ME Equipment
This section includes a list of error messages and frequently
asked questions for problems you may encounter with your blood
pressure monitor. If the products not operating as you think it
should, check here before arranging for servicing.
Battery powered mode:
6VDC 4*AAA alkaline batteries
AC adaptor powered mode: 6V 1A (Not included)
(Please only use the recommended AC adaptor model).
Digital LCD display V.A.140mm*36mm
Approx.180mm*100mm*40mm
4*AAA batteries,user manual
IP21 It means the device could protected
against solid foreign objects of 12.5mm and
greater, and protect against vertically falling
water drops.
A temperature range of :+5°C to +40°C
A relative humidity range of 15% to 90%,
non-condensing, but not requiring a water
vapour partial pressure greater than 50 hPa
An atmospheric pressure range of :
700 hPa to 1060 hPa
Temperature:-20°C to +60°C
$UHODWLYHKXPLGLW\UDQJHRIQRQFRQGHQVLQJ
at a water vapour pressure up to 50hPa
PROBLEM SYMPTOM
CHECK THIS
REMEDY
No power
Low
batteries
Error
message
Display is dim or
will not light up.
Batteries are exhausted. Replace with new batteries
Insert the batteries
correctly
Replace with new batteries
Batteries are inserted
incorrectly.
Show on
the display
Batteries are low.
E 1 shows
Refasten the cuff and then
measure again.
E 3 shows
Movement can affect the
measurement.Relax for a
moment and then
measure again.
E 10 or
E11 shows
EExx,shows on
the display.
A calibration error
occurred.
Retake the measurement.
If the problem persists,
contact the retailer or our
customer service
department for further
assistance.Refer to the
warranty for contact
information and return
instructions.
Warning
message
Relax for a moment.
Refasten the cuff and then
measure again. If the
problem persists, contact
your physician.
“out ” shows
Out of measurement
range
The monitor detected
motion,talking or the
pluse is too poor
while measuring.
Relax for a moment and
then measure again.
E 21shows
The treatment of the
measurement failed.
AC adaptor is inserted
incorrectly.
Insert the AC adaptor
tightly
The cuff is not secure.
E 20 shows
The measurement
process does not detect
the pulse signal.
Loosen the clothing on the
arm and then measure
again.
The cuff is not secure.
Readjust the cuff and
relax for a moment
and then measure again.
Summary of Contents for PULSARMATIC
Page 20: ......
