Magewell Ultra Encode, User Manual, Reference And Faq, Page: 46 / 63

Setting SmartEDID
NOTE: This function is available for HDMI products.
EDID
Click and enter the EDID tab to check the EDID information. By clicking Reset to Default in the bottom right corner of the page, you can cancel your settings.
This tab is only available for HDMI products.
TM
SmartEDID
■
TM
SmartEDID is enabled by default. When it is disabled, other related
functions can not be set.
■
TM
Depending on the input capability of the encoder and that of the device
connected to the loop-through interface, the encoder will smartly select
to send the EDID to the video source device, to ensure both the encoder
and the loop-through device can obtain the signal they support.
■
Keep last
■
Keep the last EDID value used.
■
This function is disabled by default. To enable it, the SmartEDID function
should also be enabled. When Keep Last is enabled and the loop-
through device is disconnected, the current EDID will still be used. The
encoder will continue receiving signal so the video capture and encoding
continues. Otherwise, the encoder will resend its EDID to the source
device for it to redetermine what format of signal to send. As a result,
there could be an interruption to the source signal for a short time.
■
46