ADJUSTING THE MAGENTA TT10 TURNTABLE
adjust the size of the image so that two squares are 10 mm (=1 cm).
A member of a forum rightfully pointed out that, for a long time, I had given different measurements: 63 and 120 mm. He was right of course.
Nevertheless the deviation was not too far from the measurements given by Baerwald. It all depends on where you want the zero degree
tracking error.
Place the cartridge over the 120.9 mm
line with the needle tip precisely at the crossing. The cartridge's body should be parallel to that line.
Now lift the cartridge, move it and place it over the 66 mm mark. Again the needle tip has to be placed exactly at the point where the lines
cross (you need to turn the platter a little by hand). Then at that point the cartridge's body should again be parallel to the line when the
diamond tip is placed over the spot.
You have to adjust the arm and cartridge in such a way that at both points the configuration is exact.