Specifications
MultiView™ II DVI-Rx-1K
Installation and User Guide
1
Chapter 1
Specifications
The following table lists the general specifications of the MVII-DVI-Rx-1K.
Table 1: MVII-DVI-Rx-1K General Specifications
Item
Description
Compatible transmitter
The MVII-DVI-Rx-1K receiver MUST be used with a MVII-DVI-Tx transmitter
. Use of
any other MultiView transmitter will result in no displayed image at the receiver.
Link Cable Required
4 twisted-
pair “FTP” type cable is recommended for performance and EMC
compliance.
Regular or minimized-skew type is acceptable.
Supported Video
Formats
VESA and CEA video formats, output on a digital DVI-D connector.
Supported video formats include 1080p/60/24. Refer to Appendix-A for a full list of
supported resolutions.
Audio Signals
(A) mode:
Analog audio outputs: Capable of driving a 10K ohm load (unbalanced).
(S/PDIF mode):
For S/PDIF digital-audio, 75 Ohm (typical impedance).
Note: The DVI-Tx (transmitter) can also de-embed 2CH-PCM digital audio, which can
be extracted as a S/PDIF digital audio stream at the receiver.
Serial Characteristics
(S) mode:
Protocol: Asynchronous; transparent to data format; transparent to data
rates up to 115 kbps; simplex.
(SAP) model:
Protocol: Asynchronous; 9 fixed baud rates are supported, refer to SAP-
II Programming Manual for additional details
Connectors
(1) 4 pin phoenix
(2) RJ-45 (1 input, 1 active loopthrough)
(1) DVI-D (F)
(1) DB9M (only if the SAP option module is installed)
(1) DC Power jack
Temperature/Humidity
Tolerance
Operating: 32 to 104°F (0 to 40°C), 10% to 80% RH non-condensing.
Storage: -4 to +140°F (-20 to +60°C), 10% to 80% RH non-condensing.
Enclosure
Steel, black powder-coat finish.
Power
Input voltage: +5 VDC @ 1.2 Amps max.
Consumption: 6 watts maximum
Size
1.2"H x 5.5"W x 3.6"D (3.0 x 14.0 x 9.2 cm)
Weight
1 lb. (0.45 kg)