17
PROBLEM
POSSIBLE CAUSES
WHAT TO DO
4. RED light at the
top of the
Power Meter
is lit (solid/
flashing)
Salinity is high
(Solid red light)
Salinity is very high
(Flashing red light).
System will continue to operate
properly, but no further salt should be
added. Professionally test the salt
level. If above 5500 ppm, it is
recommended to drain part of the
pool water and refill with fresh water.
Salinity is extremely high
The salt level is exceedingly high, and
should be reduced immediately by
draining a significant amount of pool
water and refilling the pool.
5. Lights
go up
& down
quickly
Short Circuit in cell cable
Check that cell wires are properly
fastened and there is no visible
reason to “short circuit” between
them.
Salinity
low.
Refer to Troubleshooting section
“Salinity Low”.
Dirty Cell.
Check Cell for white buildup, if
present, refer to maintenance section
“Cell Cleaning”
Loose connection with the
Cell’s connection pegs.
Tighten connections with a screw
driver.
6. Power Meter
lights do not
reach 100%
after turning
Control Knob to
higher setting.
Old Cell
If none of the above resolutions
worked, the cell may be worn out.
7. Red Flow Light
is OFF.
Normal Operation
This is normal.
