MB197UC, -BK, -BL, -FBK, -GRAY, -LG, -OR, -WT, -YE
2
Rev. 12/22/15
OWNER'S MANUAL
MB197UC, -BK, -BL, -FBK,
-GRAY, -LG, -OR, -WT, -YE
3 DRAWER
DELUXE UTILITY CART
1A
13
7
1A
7
13
Due to the weight of this cart we recommend that
TWO PEOPLE
work together on the assembly. This cart weighs approximately 200 lbs, please use caution
during assembly.
Step 1:
Locate the key tied to the bottom shelf. Using the key, open the
sliding top, move the lever to unlock the drawers, and remove
the caster box from the bottom drawer. Once removed, make
sure all drawers are completely closed and the inside lever is in
the locked position. Close the sliding top and lock.
Step 2:
Lay out a work surface using the protective foam provided. Once
this surface is secure, gently turn the cart onto its back.
Step 3:
(Before assembling the legs, remove the cable tie holding the
bumper in place.) Insert the front leg (Part #7). Then place the
front bumper (Part #13), labeled FL or FR, over the leg, aligning
the center bolt holes. With holes aligned, insert Torx bolt (Part
#1A) and finger tighten.
Step 4:
Install back leg (Part #7) and bumper (Part #13), labeled BR or
BL, following the same procedure as above.
Step 5:
Repeat steps 3 & 4 to mount the legs on the opposite side.
ASSEMBLy INSTRUCTIONS
Step 6:
Mounting casters: Put the four casters in place. The two locking
casters (Part #10) should be on one side of the cart, and the two
non locking casters (Part #9) should be on the other
(Left or right
side, NOT front or back)
. Using the 16 bolts (Part #8), washers,
and lock washers (located in separate caster bag), completely
tighten the casters to the bottom tray, using a 13mm socket or
13mm combination wrench for the bolt head. (Note: Bolt head,
washer and lock washer should be on the inside of the bottom
shelf.)
1A
10
9
8
