9
in
fo@mag-audio
.c
om
Tel./F
ax:
+
38 044 277
-4
7-89
www
.mag-audio.com
Hornet Line Array User Manual rev 0.1
4.1. System operation - Rigging
Connecting two HORNET 12 modules
- Make sure six pieces of VA-0018 pins
are available to perform the connection
(included in each HORNET 12 module) (pic.
1).
- Pull out frontal links on the lower cabinet.
Pull out, set the approriate angle, and
secure with VA-0018 pins rear links on
the lower cabinet (pic. 2). For detailed
instructions on operating HORNET 12
rigging hardware, refer to “4.1. System
operation - Rigging / HORNET 12 rigging
hardware operation guide“ section, page 8.
- Attach two HORNET 12 modules
together, and secure the connection with
four VA-0018 pins. (pic.3).
No more than 16 pcs of HORNET 12 may
be assembled in a flown stack.
Connecting HORNET 12 module to HTF-01
flying frame
- Position elements as shown on pic.1.
HTF-01 flying frame’s side links should
point upwards. Pull out frontal links. Pull
out, set the approriate angle, and secure
with VA-0018 pins rear links on the lower
cabinet. HORNET 12 links should be
pointing upwards.
- Attach HORNET 12 cabinet to HTF-01
flying frame, and secure connection with
four VA-0018 pins (pic. 2). For detailed
instructions on operating HORNET 12
rigging hardware, refer to “4.1. System
operation - Rigging / HORNET 12 rigging
hardware operation guide“ section, page 8.
- HTF-01 allows to attach HORNET 12
cabinet with 0°, negative 2,5° and 5° angle.
(“0°“ socket of the HORNET 12 module).
(pic.3).
No more than 16 pcs of HORNET 12 may
be assembled in a flown stack.
1
1
3
3
2
2
0°
2,5°
5°
