![background image](http://html.mh-extra.com/html/mafell/p1cc-series/p1cc-series_operating-instructions-and-spare-parts-list_689026019.webp)
-19-
chip board, coreboard and MDF board, synthetic
materials, mineral building materials and metals.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
So as to use the machine as intended, comply with
the operating, maintenance and repair instructions
specified by Mafell.
2.9
Residual risks
Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
-
Touching the saw blade below the guide plate.
-
Touching the part of the saw blade that protrudes
below the workpiece when cutting.
-
Machine backlash if the blade gets stuck in the
workpiece.
-
Breakage of the saw blade and risk of the blade or
pieces of the blade being hurled away.
-
Touching live parts with the housing open and the
mains plug not removed.
-
Hearing can be impaired when working for longer
periods without ear protectors.
-
Emission of harmful wood dusts during longer
operation without extraction.
3
Safety instructions
Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
General instructions:
-
Children and adolescents must not operate this
machine. This rule does not apply to young
persons receiving training and being supervised by
an expert.
-
Never work without the protection devices
prescribed for the respective operating sequence
and do not make any changes to the machine that
could impair safety.
-
When operating the machine outdoors, use of an
earth-leakage circuit-breaker is recommended.
-
Damaged cables or plugs must be immediately
replaced.
-
Avoid sharp bends in the cable. Especially when
transporting and storing the machine, do not wind
the cable around the machine.
Do not use:
-
Cracked and misshapen saw blades.
-
Blunt saw blades as they impose an excessive
load on the motor.
Instructions on the use of personal protective
equipment:
-
The noise pressure level at the ear generally
exceeds 85 dB(A). Operators should therefore
wear ear protectors.
-
Wear protective goggles.
-
Wear a dust mask.
Instructions on operation:
-
Do not reach with your hands into the sawing area
and do not touch the saw blade. Hold the machine
with both hands at the grip areas intended.
-
Do not reach under the workpiece.
-
Never support the workpiece in your hand or over
your leg. Secure the workpiece against a sturdy
support.
-
Only hold the device by its isolated handle
surfaces when carrying out work during which the
cutting tool could hit hidden power cables or its
own connection cable.
-
If you would like to restart a saw that is stuck in the
workpiece, centre the saw blade in the saw slit and
check whether the saw teeth are stuck in the
workpiece.
-
Support large plates to reduce the risk of backlash
caused by a jammed saw blade.
-
Do not use any blunt or damaged saw blades.
Summary of Contents for P1CC Series
