-24-
Only for EC countries:
According to the European
Guideline 2002/96/EC, power tools
that are no longer usable, and
according to the European
Guideline 2006/66/EC, defective or
used battery packs/batteries, must
be collected separately and
disposed of in an environmentally
correct manner.
Battery packs/batteries:
Li-Ion:
Please observe the instructionsin
section “Transport”,page 23.
Subject to change without notice.
7 Troubleshooting
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Unplug the rechargeable battery
beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Cause
Elimination
Rechargeable battery empty
Charge the rechargeable battery
Rechargeable battery not
engaged in end position
Allow rechargeable battery to
engage completely
Machine cannot be switched on
Carbon brushes worn
Take the machine to a MAFELL
customer service shop
Machine stops while cutting is in
process
Machine overloaded
Reduce feed speed
Feed rate too fast
Reduce feed speed
Blunt saw blade
Release the switch immediately.
Remove the machine from the
workpiece and replace the saw
blade
Tension in the workpiece
Poor machine guidance
Use parallel stop
Saw blade jams as the machine is
advanced
Uneven workpiece surface
Straighten the surface
Burn marks on the cut surfaces
The saw blade used is unsuitable
for the task or blunt
Replace saw blade
Wood is too damp
Chip ejection blocked
Extended operation without
extraction
Connect to an external extraction,
e.g. portable dust extractor
