![background image](http://html.mh-extra.com/html/mafell/mks-130-ec/mks-130-ec_translation-of-the-original-operating-instructions_689052026.webp)
-26-
existing edge without retooling. The cutting range on
the right-hand side amounts to 140 mm (5 1/2 in.) and
on the left-hand side to 320 mm (12 5/8 in.).
In order to adjust the cutting width, unscrew the
wing screws 14 (Fig. 4) and move the guide
fence accordingly. Afterwards, retighten the
wing screws 14.
In addition, it is possible to turn the guide fence plate
20 (Fig. 2) of the parallel guide fence by 90°. With
that it is possible to use the guide fence surface both
above and below the base plate. If a straight
workpiece edge is already available and if a parallel
cut is to be made to this, the guide fence plate 20 is
turned down.
If there is no straight workpiece edge, the guide fence
plate is turned up to carry out a straight cut.
Now the machine can be guided either along a lathe
fastened on the workpiece or along the guide rail that
is available as optional accessory.
6
Service and maintenance
Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
6.1
Storage
If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
7
Troubleshooting
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Cause
Elimination
Machine cannot be switched on
No mains voltage
Check power supply
Mains fuse defective
Replace fuse
Carbon brushes worn
Take the machine to a MAFELL
customer service shop
Machine stops while cutting is in
process
Mains failure
Check mains back-up fuses
Machine overloaded
Reduce feed speed
Saw blade jams as the machine is
advanced
Feed rate too fast
Reduce feed speed
Blunt saw blade
Release the switch immediately.
Remove the machine from the
workpiece and replace the saw
blade
Tension in the workpiece
Poor machine guidance
Use parallel guide fence
Uneven workpiece surface
Straighten the surface