-31-
For bevel cuts, the tracing can be viewed through the
opening on the left-hand side of the upper saw guard.
Hold the machine by its handles and place the
front part of its base plate onto the workpiece.
Switch on the portable circular saw (see chapter
5.2) and slide the machine evenly forward in the
direction of the cut.
When the cut is completed, switch off the saw
by releasing the switch trigger 10 (Fig. 2).
5.8
Sawing with the parallel stop
The parallel stop serves to saw parallel to an already
existing edge. The limit stop can be attached to the
left or right of the machine. While doing so, the cutting
range amounts to 33 - 130 mm on the right-hand side
(reading indicator "X" Fig. 1) and to 163 - 300 mm on
the left-hand side (reading edge at indicator edge "Y"
Fig. 1).
You can adjust the cutting width after releasing
the wing screws 20 (Fig. 3) by moving the limit
stop accordingly and afterwards retightening the
wing screws.
In addition, by simply turning it around (guide face for
the workpiece edge points upwards), the parallel stop
can also be used as double support to improve
guidance of the portable circular saw. Now the
machine can be guided along a guide that is fastened
on the workpiece.
5.9
Working with the roller edge guide
The roller edge guide serves to work parallel to an
already existing edge. The limit stop can be attached
to the left or right of the machine. The cutting range
on the right-hand side amounts to approx. 12 - 40 mm
(0.47 - 1.57 in.) and on the left-hand side to approx.
30 – 210 mm (1.18 - 8.27 in.).
You can adjust the cutting width after releasing
the wing screws 20 (Fig. 3) by moving the limit
stop accordingly and afterwards retightening the
wing screws.
6
Service and maintenance
Danger
Unplug the rechargeable battery for
all service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
6.1
Storage
If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
6.2
Transport
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further
requirements.
When being transported by third parties (e.g.: air
transport or forwarding agency), special requirements
on packaging and labelling must be observed. For
preparation of the item being shipped, consulting an
expert for hazardous material is required.
Dispatch batteries only when the housing is
undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot
move around in the packaging.
Please also observe possibly more detailed national
regulations.
6.3
Disposal of rechargeable batteries/batteries
The machine, rechargeable
batteries, accessories and
packaging should be sorted for
environmental-friendly recycling.
Do
not
dispose
of
power
tools
and
batteries/rechargeable batteries into household
waste!
Summary of Contents for K 65 18M bl
Page 2: ...3...
