![background image](http://html2.mh-extra.com/html/mafell/fm-1000/fm-1000_translation-of-the-original-operating-instructions_3386965024.webp)
-24-
5
Operation
5.1
Initial operation
Personnel entrusted to work with the machine must be made aware of the operating instructions, calling
particular attention to the chapter "Safety instructions".
This operating manual only deals with the milling motor and not with the installation situation. Please take note
of any other operating manuals.
5.2
Switching on and off
Switching on: Push the switch 5 (Fig. 1) forward until it engages.
Switching off: Push onto the rear end of the switch. The switch jumps into off position.
The built-in electronic system provides for jerk-free acceleration when the machine is switched on and under
load readjusts the speed to the fixed setting.
In addition, this electronic system reduces the motor output in case of an overload, i.e. the spindle stops.
Switch the machine off then. Then switch the machine on again and continue working at a reduced feed speed.
With the setting wheel X (Fig. 2) you can adjust the speed continuously. Appropriate speed values at the
different levels can be referenced in the table on page 3.
5.3
PV (portal version)
With the PV version Y (Fig. 2) you can control the speed via the machining system.
If the PV output is not used, please use the cover cap. The diagram for the operating mode and speed control
is shown in Fig. 5.
Input
Output
HS [-]
U
AC
[VAC]
U
PV
[V]
PS
S
[-]
U
S
[V]
Operating mode
n [rpm]
OFF
N/A
N/A
N/A
N/A
Out of operation
0
ON
0
N/A
N/A
N/A
Out of operation
0
ON
198-253
< 7
1
N/A
Manual operation 4,000
ON
198-253
< 7
6
N/A
Manual operation 25,000
ON
198-253
7-56
N/A
0
Portal operation
4,000
ON
198-253
7-56
N/A
10
Portal operation
25,000
Summary of Contents for FM 1000
