Mafell FM 1000, Translation Of The Original Operating Instructions

Page: 23 / 142

-23-
4 Setting / Adjustment
4.1 Mains connection
Prior to commissioning make sure that the mains voltage complies with the operating voltage stated on the
machine's rating plate.
4.2 Selection of tools
Only use the collets/reducing sleeves listed in chapter 8 Optional accessories.
4.3 Tool change
Danger
Pull the power plug during all service work.
Wear protective gloves during a tool change. The insertion tool can get very
hot during longer operation and/or the insertion tool’s cutting edges are sharp.
The spindle 1 (Fig. 1) of the milling and grinding motor is equipped with a precision collet 2 (Fig. 1) to hold the
tools. Tightening and releasing the unit nut 3 (Fig. 1) is made easy with a spindle lock 4.
Proceed as follows for the tool change:

Lock the spindle 1 (Fig. 1) to unclamp the tool by pressing the locking button 4 (Fig. 1).

Detach union nut 3 with an open-ended spanner AF 17.

Pull off the tool to the front.
 Push the new tool into the tool holding fixture up to the limit stop.

Check the tool’s seat.

Spindle 1 is locked when the tool is clamped.

Tighten union nut 3 with the open-ended spanner
4.3.1 Quick tool clamping

Switch on the machine only when the lever 6 (Fig. 3) is not in the tool
change position.

Do not actuate lever 6 (Fig. 3) until the machine is at a standstill.
The spindle 7 of the quick tool clamping device is equipped with a precision holding fixture for a tool shank Ø 8.
Proceed as follows for the tool change:

To unclamp the tool, move lever 6 (Fig. 3) forward up to the stop.

Pull off the tool to the front.

Push the new tool into the tool holding fixture up to the limit stop.

Check the tool’s seat.

To clamp the tool, move the lever back to its original position.